For ultimate dent removal, moulding rivet installation, and shrinking/expanding metal.
REMOVE DENTS professionally in hoods, fenders, deck lids, or any other sheet metal panel on your vehicle or tractor. Simply plug Magna-Spot® into 115 volt 15 amp outlet, insert draw pin into electrode tip, hold against clean metal surface, and press trigger 1/2 to 1 second. Instantly, Magna-Spot® welds draw pin to metal surface where it can be pulled out using slide hammer (included in kit). Once dent is pulled, grind off draw pins flush with metal surface, and finish with body filler. For large dents, weld several pins in a series.
MOULDING TRIM RIVETS for holding aluminum, stainless, or plastic trim clips can also be welded using the rivet electrode and rivets. Insert trim rivet into electrode tip, place against clean metal surface until outer ring is seated, press trigger 1/2 to 1 second, and rivet is now welded to metal. After painting, plastic or metal trim clips will slide over rivets and hold your trim in place.
SHRINK HIGH SPOTS & EXPAND SMALL DENTS by using shrink/expand electrode. Place Magna-Spot® Welder against clean metal surface until outer ring is seated, press trigger 1/2 second, 2-3 times to heat metal. Generally, small high spots will disappear. If high spot does not shrink, tap lightly with body hammer. If a dent does not expand, apply a damp cloth to the heated metal to raise the surface.
JO1500 Magna-Spot® Professional Stud Welder Kit includes: 1500 Stud Welder, heavy-duty slide hammer, draw pin electrode tip, trim rivet electrode tip, shrinking/expanding electrode tip, (500) 2.0 mm draw pins, 150 trim rivets, and case. Ship wt: 28 lbs.
Made in USA.